In ALTERA Monitor it works, in Eclipse EDS it doesn't?

Annonces et discussion des événements du jeu

Modérateur: musique

In ALTERA Monitor it works, in Eclipse EDS it doesn't?

Messagepar jesuslewis » Sam Août 05, 2017 8:30 am

Hello,

I have followed the tutorial "Introduction to Qsys" from the ALTERA University program where a very small VHDL system is created plus an instantiation of the Nios II and some switches as inputs and some LEDs as outputs assigned at the pins.

I wrote and compiled the program that justs propagates the switch values to the LEDs using the ALTERA Monitor program and it works fine.

When I try to do the same using the Nios EDS in Eclipse it compiles perfectly but when the program gets downloaded into the device the LEDS not only do they not follow the switch values but they do not light up at all.

In order to do the example in Eclipse EDS I just created an application and BSP from the template small Hello world and added the AVALON-MM addresses of the swithes and the LEDs plus the propagation command.


I didn't find the right solution from the internet.
References:
https://www.alteraforum.com/forum/showt ... 64669f0274
Trademark Management Video Examples
jesuslewis
 
Messages: 96
Inscrit le: Jeu Juil 06, 2017 2:33 pm

Retour vers Evénements

cron